Quick Performance
My Account
Shopping Cart 0 item(s)
View Cart
ARB 4x4 Accessories
Quick Performance Inc.
Auburn Gear
BMR Suspension
Green Bearing Company
Moser Engineering
Motive Gear
Quick Performance
Spartan Locker
Strange Engineering
TA Performance
UMI Performance
USA Standard Gear
US Gear
Yukon Dura Grip
Yukon Gear & Axle
Yukon Gear Ring & Pinion Sets
Yukon Grizzly Locker
Yukon Hardcore
Yukon Mighty Seal
Yukon Zip Locker
Home†>†Ford 8 Inch (8" Ford)

Ford 8" Complete Center Section / Third Member

Part Number F8C
review 6 Review(s)
Ford 8" Complete Center Section / Third Member
item may differ from picture
Write a Review Write a Review
Your Price:  
Choose Options
Carrier Options
Case Upgrade
Pinion Support
Fill plug
Gear Ratio
4.62 [+$10.00]
Include LubeLocker Gasket
Add to Wish List

  • Fully Assembled, Ready to Bolt in
  • Reconditioned, stock case, yoke & pinion support (not intended for high HP)
  • New Timken USA Bearings
  • New Motive Performance Ring & Pinion
  • New Carrier (Trac-lok Clutch posi, Eaton Truetrac, etc.)
  • Your Choice of Gear Ratio & Traction Device
Customer Reviews View All Reviews
Rating Ford 8" Complete Center Section / Third Member
I did quite a bit of searching for the right rear end for my 1966 Mustang. I have built the car through the years as a driver (300+ HP, OHD, Air,etc.) that makes cross country trips. Last year with the OHD, the stock gear was a little to high for the mountains from Indiana to Reno, NV. I opted for the 3:40 open. This is the best for my primary use as a car that can handle the mountains as well as cruise with some low end power. The installation was easy and after over 500 miles, the gear is performing as expected, quiet, smooth, improved take offs and improved gas mileage because the engine is not working hard. I would recommend Quick Performance and put my trust in the guys that have a great reputation and make it simply for the hobbyist.
  Did you find this helpful?    472 of 477 Found Helpful
Reviewed by:  from COVINGTON. - 5/9/2016
Rating 8" Tru Trac
Great packaging, easy installation and heat cycles instructions. After the heat cycles I hammer on it ever week. The Tru Trac hooks up.
  Did you find this helpful?    58 of 61 Found Helpful
Reviewed by:  from Orono, MN. - 5/3/2016
Rating Ford 8" Third Member
I previously bought an 8" third member with 4.62 gears and it was fantastic in my 70 mustang. I have another 70 mustang I'm building, more for the street, and got the same 3rd member but with 3.80 gears. Much more freeway friendly. Both 3rd members perform great!
  Did you find this helpful?    41 of 44 Found Helpful
Reviewed by: (Verified Buyer)  from Anaheim, California. - 6/15/2016
Rating customer
Quick Performance has now built two third members for my use. One 8" and one 9" Ford. Great customer service. Excellent build on both units. Great quality. I would highly recommend Quick Performance to everyone.......
  Did you find this helpful?    26 of 29 Found Helpful
Reviewed by:  from Columbus, Ohio. - 5/12/2016
Rating Third member was a very good quality piece
Thanks Mike! Installed without a problem and worked great! Iíll recommend Quick Performance to all my friends.
  Did you find this helpful?    19 of 22 Found Helpful
Reviewed by:  from GA. - 4/14/2016
Related Items
AAM 10.5
AAM 10.5" / LubeLocker / Premium Gasket
Average Rating 0 Review(s)
Your Price: $21.95
GM 7.5
GM 7.5" & 7.625" 10 Bolt / Axle Bearing & Seal Kit (1 Pair)
Average Rating 0 Review(s)
Your Price: $33.50
Ford 8
Ford 8" / Ring and Pinion / US Gear
Average Rating 1 Review(s)
Your Price: $209.00
Ford 8
Ford 8" / LubeLocker / Premium Gasket
Average Rating 0 Review(s)
Your Price: $21.95
Chrysler 9.25 / Solid Pinion Spacer / Crush Sleeve Eliminator
Chrysler 9.25 / Solid Pinion Spacer / Crush Sleeve Eliminator
Average Rating 0 Review(s)
Your Price: $16.75
GM 12 Bolt Car / Ring Gear Spacer
GM 12 Bolt Car / Ring Gear Spacer
Average Rating 0 Review(s)
Your Price: $32.00
Recently Viewed Items

Items may be different than pictured. Prices and availability are subject to change without notice.†Terms & Conditions